Standby Amplifier Changeover Unit
AX3800
8 duty / 1 standby Auto Amplifier Changeover Unit


AX3800 - End of Life
Highlights
8 duty / 1 standby, Cascade to enable 16 duty / 1 standby
Priority changeover and overloading protection of standby amplifier
RS485 and dry contact for external monitoring
AX3800 is 8 duty / 1 standby auto changeover unit , providing a switching platform for standby unit to replace the position of failed duty amplifier. Should one standby unit is required to serve more than 8 power packs, more than one AX3800 can be cascaded.
​
It provides switching both at input and output section, thus suitable for matrix system where all amplifiers has different input sources. Detection is via 20 KHz, which is inaudible to human ears.
​
While it is compatible for most makes of amplifiers, please check the specifications of the amplifiers as they may have high frequency cut off, which would make the overall changeover functions unstable.
Features
-
8 duty / 1 standby setup
-
Cascade feature available
-
Built in Pilot Tone transmitted at intervals to reduce amp loading
-
Overloading protections with single changeover
-
Prioritised changeover
-
Short detection from 7 to 15 seconds
-
Input and output section switching
-
Easier connections for links
-
Channel isolation for unused ports
-
RS485 data port
Technical Specifications
Operating voltage
Power consumption
​
Configuration
Input signal
Input impedance
Input gain
Pilot tone
​
Zone load
Detection
Detection level
Failure detection
Failure recovery
​
Indications
​
Connectors
Cable size
Cascade
​
Dimensions
Weight
24V DC ; 1 A
6.8 W
​
8 duty / 1 standby
8 Ch balanced
10 K Ohm
Unity
20 KHz / 8 secs interval
​
500W 100V or
1000W 100V ( on request )
70 / 100V line
50V rms min
7 to 15 seconds
20 sec max
​
Front panel LED
Buzzer
​
Phoenix
2.5 mm
2
​
482 X 88 X 180 mm
3.15 kg
Documents
Catalogue
Instruction Manual
ACAD Image
Rear View
